IPK Impulse Sealers

Impulse Sealers

Impulse Heat Sealers are designed for the continuous sealing of thermoplastic films such as polyethylene and polypropylene. These sealers operate on the impulse sealing method, controlled by a plug-in transistorized circuit board. They work by delivering an instantaneous high current impulse to a heater ribbon on the device surface.

Coming in a variety of sizes and used for multiple applications, impulse sealers are found in many industries including food packaging, manufacturing, construction, apparel, and the medical community. Because of their ease of use, low energy costs, light weight, exceptional safety standards, and consistent reliability, there is a growing demand for impulse heat sealers.

Download the Instruction Manual for all of our IPK sealers.

Easily Interchangeable Nichromes

Benefit:
This system gives you the most for your packaging dollar. A wide seal for improved seal integrity on hard to seal materials and a narrow seal for aesthetics or tear seal applications.

Feature:
One Machine - two interchangeable seal widths. You can switch between the 5mm(1/4") or 2mm(1/16") element in seconds without special tools.

All Metal Construction

Benefit:
All metal construction will stand up to the long term daily use of any packaging or sealing need.

Feature:
The body is formed out of rugged cast aluminum and the pivot is all steel

Solid State Impulse Timer

Benefit:
With a simple turn of the dial your impulse hand sealer accurately seals a wide variety of thermal plastics exactly - every time.

Feature:
A turn of the timer is all it takes to accurately set heat seal time. A steady red, then blinking, light indicated the heat seal cycle is completed

UL Approved

Benefit:
You can have the peace of mind knowing these machines meet stringent electrical saftey standards.

Feature:
The Hand Impulse Sealer is marked with the respected Underwriters Laboratories certification

IMPORTANT

*PTFE Flouropolymer Adhesive & *PTFE Flouropolymer Cover MUST BE REPLACED when heating element has burned through the *PTFE Flouropolymer. Replacement *PTFE Flouropolymer ADHESIVE (BOTTOM *PTFE Flouropolymer) MUST ALWAYS extend 1/2" past the machine on both ends & then be bent down. This is the only barrier berween the metal machine & metal heating element. Heating element will break if instruction is not followed.

This is why you should ALWAYS purchase a spare parts kit for your sealer at the time of purchase.

Each kit contains: 2 replacement nichrome elements and 2 replacement *PTFE Flouropolymer covers. When used properly, impulse sealers will seal 3,500-5,000 times before the element (and adhesive *PTFE Flouropolymer and *PTFE Flouropolymer cover) needs to be replaced.